Small Cable Hole Locations

Download PDF

Small Cable hole locations

1. Drill a 1 1/8″ hole at approximately 7″ down from the top and
   approximately 33″ over from the vertical return flange on the
   angled right side roof panel.

2. Mount the supplied Boom HV mount at approximately 11″ outside
   of the right lower 3pt pin framing or just inside of the center section
   right pocket when seated inside the tractor cab facing forward.

3. Route the new HV cable through both hole attaching the conduit
   TIGHTLY to both mounts using the supplied steel ends with nuts.
   Use channel locks to tighten.
4. Route the new cable across the top of the right fiberglass arm
   towards the front electrode.